This test method covers the procedure for testing the tensile breaking strength of the perforations in one-part continuous forms paper.
This test method provides a quick, reliable means to measure the wet zero-span tensile strength of a specimen of sheeted material.
This test method provides a quick reliable means to measure the zero-span tensile strength of a randomly oriented specimen of fibers when dry.
This test method covers measurements of the bursting strength of paper and paper products occurring as single or laminated flat sheets not over 0.6mm. (0.025 in.) in thickness having a bursting strength of 30 kPa up to 1400 kPa (4 psi up to 200 psi).
This test method covers procedures for determining tensile properties of paper and paperboard.
These test methods measure the (wet) tensile breaking strength of paper, paper products, and paperboard (excluding corrugated board) when saturated with water.
BS 2922-2:1984, ISO 3781-1983
Strength of wet paper and board. Method for determination of the tensile strength of paper and board after immersion in water.
BS 3748:1992, ISO 2493:1992
Method for determination of resistance to bending of paper and board.
BS 4415-1:1992, ISO 1924-1:1992
Determination of the tensile properties of paper and board. Constant rate of loading method.
Method for the determination of the puncture resistance of board.
BS 7325:1990, ISO 9895:1989
Method for determination of the compressive strength of paper and board by the short span test.
BS EN 12625-4:1999
Tissue paper and tissue products. Determination of tensile strength, stretch at break and tensile energy absorption.
BS EN 12625-5:1999
Tissue paper and tissue products. Determination of wet tensile strength.
BS EN ISO 1924-2:1995
Paper and board. Determination of tensile properties. Constant rate of elongation method.
BS ISO 11093-6:1996
Paper and board. Testing of cores. Determination of bending strength by the three-point method.
BS ISO 11093-7:1997
Paper and board. Testing of cores. Determination of flexural modulus by the three-point method.
BS ISO 12192:2002
Paper and board. Compressive strength. Ring crush method.
BS ISO 1924-3
Paper and board. Tensile strength, strain at break, tensile energy absorption and tensile stiffness. Part 3. Constant rate of elong ation method (100 mm/min).
Paper and board. Testing of cores. Part 6. Determination of bending strength by the three-point method.
The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.